PIN-CLIP ---> It's for the DIYer , this kit come with FULL PINs for support almost chips, after the complete soldering then can plug and play, don't need solder to the wii mother board at all.
So the point of PIN-CLIP is : You don't need solder anything to your Wii motherboard, keep your Wii more safe and don't lost the guarantee, and easy for replace with other chip!
Q&A
Q: I have bought your PIN-CLIP and are going to install my Argon SPI 9 wire modchip to it. I have a question about this because the PIN-CLIP has two GND and two VCC connections. The Argon operates at 3V but there is no 3V connection on the PIN-CLIP, I assume the VCC connection is the same? Since I don’t have thicker Kynar wire for the power and ground connections I’m just going to twist two AWG30 Kynar wires together. What is in this case the best way to solder these twisted wires to the PIN-CLIP? Take a look at the included image that I made and tell me which option you recommend for soldering the VCC and GND connections of the PIN-CLIP to the Argon.
|
 Modchip for Wii.jpg)
